Standard

Сравнение возможностей углеродных сорбционно-активных материалов для экспрессного концентрирования летучих органических соединений из потока анализируемого воздуха. / Rodinkov, Oleg V.; Postnov, Viktor N.; Bugaychenko, Alexandra S.; Valery, Spivakovsky.

в: Sorbtsionnye i Khromatograficheskie Protsessy, Том 21, № 3, 16.06.2021, стр. 307-316.

Результаты исследований: Научные публикации в периодических изданияхстатьяРецензирование

Harvard

APA

Vancouver

Author

BibTeX

@article{308459562e3e48e79df667a7ed705cbc,
title = "Сравнение возможностей углеродных сорбционно-активных материалов для экспрессного концентрирования летучих органических соединений из потока анализируемого воздуха",
abstract = "Carbon sorbents are widely used for dynamic sorption concentration of analytes in air analysis. However, carbon and especially nanocarbon sorption-active materials have one significant drawback. Too small particles of these materials often impede their direct use in air analysis due to the low permeability of the sorption layer. The problem of low permeability of microdispersed sorption-active materials can be solved using composite surface-layer sorbents, in which these materials are located on the surface of a relatively coarsely dispersed carrier. The main goal of this study was assessment of the capabilities of surface-layer sorbents based on various carbon materials for the rapid concentration of highly toxic volatile organic compounds (medium alcohols and phenols). Surface-layer sorbents based on commercially available carbon nanotubes (Bauer, Dealton, Taunit-MD) and nanotubes synthesized by us using a cobalt catalyst have been synthesized and investigated. The listed carbon sorbents were applied to silica supports based on an aerosilogel. The choice of these carriers was due to their high thermal stability and the possibility of depositing layers of pyrocarbon and carbon nanotubes on their surface. In addition, these carriers allow creating composites with a wide variety of sorption-active carbon materials. The highest efficiency was found for surface-layer sorbents based on carbon nanotubes obtained using a cobalt catalyst. The efficiency of these sorbents in terms of HETP value was significantly higher than that of sorbents based on graphitized thermal soot (Carbopacks) with a comparable specific surface area. The advantages of surface-layer sorbents begin to manifest themselves especially strongly with a high flow rate of the analysed air. The increased hydrophilicity of some synthesized composites complicated their use in the analysis of moist air with an orientation towards the subsequent thermal desorption of analytes. However, this leaves the possibility of desorption using a suitable organic solvent, followed by determination of analytes by HPLC. The difficulties of thermal desorption of high-boiling organic compounds from the surface of carbon adsorbents are well known. For the solution of this problem, surface-layer sorbents with a pyrocarbon layer on the surface of the porochrome-3 macroporous carrier for gas chromatography with a small specific surface were synthesized. The proposed sorbents allowed performing the sorption concentration of phenol and isomeric cresols in 5 min with a concentration factor of 2?103 followed by gas chromatographic determination of analytes (flame ionization detector) at a level of several μg/m3. This creates the necessary prerequisites for the rapid determination of phenol and isomeric cresols at the level of maximum permissible air concentrations in residential premises and atmospheric air in populated areas.",
keywords = "Aerosilogel, Air, Alcohols, Analysis, Carbon nanotubes, Concentration, Phenols, Sorbents, Surface-layer, Aerosilogel, Air, Alcohols, Analysis, Carbon nanotubes, Concentration, Phenols, Sorbents, Surface-layer",
author = "Rodinkov, {Oleg V.} and Postnov, {Viktor N.} and Bugaychenko, {Alexandra S.} and Spivakovsky Valery",
note = "Publisher Copyright: {\textcopyright} 2021 Rodinkov O.V., Postnov V.N., Spivakovsky V., Bugaychenko A.S.",
year = "2021",
month = jun,
day = "16",
doi = "10.17308/sorpchrom.2021.21/3464",
language = "русский",
volume = "21",
pages = "307--316",
journal = "Sorbtsionnye i Khromatograficheskie Protsessy",
issn = "1680-0613",
publisher = "Издательство Воронежского государственного университета",
number = "3",

}

RIS

TY - JOUR

T1 - Сравнение возможностей углеродных сорбционно-активных материалов для экспрессного концентрирования летучих органических соединений из потока анализируемого воздуха

AU - Rodinkov, Oleg V.

AU - Postnov, Viktor N.

AU - Bugaychenko, Alexandra S.

AU - Valery, Spivakovsky

N1 - Publisher Copyright: © 2021 Rodinkov O.V., Postnov V.N., Spivakovsky V., Bugaychenko A.S.

PY - 2021/6/16

Y1 - 2021/6/16

N2 - Carbon sorbents are widely used for dynamic sorption concentration of analytes in air analysis. However, carbon and especially nanocarbon sorption-active materials have one significant drawback. Too small particles of these materials often impede their direct use in air analysis due to the low permeability of the sorption layer. The problem of low permeability of microdispersed sorption-active materials can be solved using composite surface-layer sorbents, in which these materials are located on the surface of a relatively coarsely dispersed carrier. The main goal of this study was assessment of the capabilities of surface-layer sorbents based on various carbon materials for the rapid concentration of highly toxic volatile organic compounds (medium alcohols and phenols). Surface-layer sorbents based on commercially available carbon nanotubes (Bauer, Dealton, Taunit-MD) and nanotubes synthesized by us using a cobalt catalyst have been synthesized and investigated. The listed carbon sorbents were applied to silica supports based on an aerosilogel. The choice of these carriers was due to their high thermal stability and the possibility of depositing layers of pyrocarbon and carbon nanotubes on their surface. In addition, these carriers allow creating composites with a wide variety of sorption-active carbon materials. The highest efficiency was found for surface-layer sorbents based on carbon nanotubes obtained using a cobalt catalyst. The efficiency of these sorbents in terms of HETP value was significantly higher than that of sorbents based on graphitized thermal soot (Carbopacks) with a comparable specific surface area. The advantages of surface-layer sorbents begin to manifest themselves especially strongly with a high flow rate of the analysed air. The increased hydrophilicity of some synthesized composites complicated their use in the analysis of moist air with an orientation towards the subsequent thermal desorption of analytes. However, this leaves the possibility of desorption using a suitable organic solvent, followed by determination of analytes by HPLC. The difficulties of thermal desorption of high-boiling organic compounds from the surface of carbon adsorbents are well known. For the solution of this problem, surface-layer sorbents with a pyrocarbon layer on the surface of the porochrome-3 macroporous carrier for gas chromatography with a small specific surface were synthesized. The proposed sorbents allowed performing the sorption concentration of phenol and isomeric cresols in 5 min with a concentration factor of 2?103 followed by gas chromatographic determination of analytes (flame ionization detector) at a level of several μg/m3. This creates the necessary prerequisites for the rapid determination of phenol and isomeric cresols at the level of maximum permissible air concentrations in residential premises and atmospheric air in populated areas.

AB - Carbon sorbents are widely used for dynamic sorption concentration of analytes in air analysis. However, carbon and especially nanocarbon sorption-active materials have one significant drawback. Too small particles of these materials often impede their direct use in air analysis due to the low permeability of the sorption layer. The problem of low permeability of microdispersed sorption-active materials can be solved using composite surface-layer sorbents, in which these materials are located on the surface of a relatively coarsely dispersed carrier. The main goal of this study was assessment of the capabilities of surface-layer sorbents based on various carbon materials for the rapid concentration of highly toxic volatile organic compounds (medium alcohols and phenols). Surface-layer sorbents based on commercially available carbon nanotubes (Bauer, Dealton, Taunit-MD) and nanotubes synthesized by us using a cobalt catalyst have been synthesized and investigated. The listed carbon sorbents were applied to silica supports based on an aerosilogel. The choice of these carriers was due to their high thermal stability and the possibility of depositing layers of pyrocarbon and carbon nanotubes on their surface. In addition, these carriers allow creating composites with a wide variety of sorption-active carbon materials. The highest efficiency was found for surface-layer sorbents based on carbon nanotubes obtained using a cobalt catalyst. The efficiency of these sorbents in terms of HETP value was significantly higher than that of sorbents based on graphitized thermal soot (Carbopacks) with a comparable specific surface area. The advantages of surface-layer sorbents begin to manifest themselves especially strongly with a high flow rate of the analysed air. The increased hydrophilicity of some synthesized composites complicated their use in the analysis of moist air with an orientation towards the subsequent thermal desorption of analytes. However, this leaves the possibility of desorption using a suitable organic solvent, followed by determination of analytes by HPLC. The difficulties of thermal desorption of high-boiling organic compounds from the surface of carbon adsorbents are well known. For the solution of this problem, surface-layer sorbents with a pyrocarbon layer on the surface of the porochrome-3 macroporous carrier for gas chromatography with a small specific surface were synthesized. The proposed sorbents allowed performing the sorption concentration of phenol and isomeric cresols in 5 min with a concentration factor of 2?103 followed by gas chromatographic determination of analytes (flame ionization detector) at a level of several μg/m3. This creates the necessary prerequisites for the rapid determination of phenol and isomeric cresols at the level of maximum permissible air concentrations in residential premises and atmospheric air in populated areas.

KW - Aerosilogel

KW - Air

KW - Alcohols

KW - Analysis

KW - Carbon nanotubes

KW - Concentration

KW - Phenols

KW - Sorbents

KW - Surface-layer

KW - Aerosilogel

KW - Air

KW - Alcohols

KW - Analysis

KW - Carbon nanotubes

KW - Concentration

KW - Phenols

KW - Sorbents

KW - Surface-layer

UR - http://www.scopus.com/inward/record.url?scp=85115314260&partnerID=8YFLogxK

UR - https://www.mendeley.com/catalogue/2118140c-f48e-3713-96ed-ee7372262565/

U2 - 10.17308/sorpchrom.2021.21/3464

DO - 10.17308/sorpchrom.2021.21/3464

M3 - статья

AN - SCOPUS:85115314260

VL - 21

SP - 307

EP - 316

JO - Sorbtsionnye i Khromatograficheskie Protsessy

JF - Sorbtsionnye i Khromatograficheskie Protsessy

SN - 1680-0613

IS - 3

ER -

ID: 86289789