This paper presents the results of a computer and experimental study of a promising severe plastic deformation (SPD) technique, called Multi-ECAP-Conform (M-ECAP-C), for the fabrication of long-length nanostructured billets (wire rods) with an enhanced strength and electrical conductivity from the aluminum alloy EN-AW 6101 per one processing cycle. On the basis of the obtained results, a new rational geometry of the pressing channel for the M-ECAP-C process has been developed. The strained state of pilot samples of wire rods have been studied. Using the method of dividing grids shows the character of accumulation and the achieved level of deformation shear during the experimental treatment, and the average value of the shear deformation of the central region of the workpiece is 3.015. It was found that the error between the obtained values of the experimental method of grids, computer modeling and calculation is, respectively, 10 % and 17 %. The error between the experimental and computer modeling is not so important, so application of the computer modeling to estimate the strain state of the method of the Multi-ECAPConform is completely adequate.

Original languageEnglish
Pages (from-to)603-607
Number of pages5
JournalMaterials Science Forum
Volume870
DOIs
StatePublished - 1 Jan 2016
Externally publishedYes
EventInternational Conference on Industrial Engineering, 2016 - Chelyabinsk, Russian Federation
Duration: 19 May 201620 May 2016

    Research areas

  • Aluminum alloys, Computer modeling, Method of dividing grids, Severe plastic deformation, Strained state

    Scopus subject areas

  • Materials Science(all)
  • Condensed Matter Physics
  • Mechanics of Materials
  • Mechanical Engineering

ID: 35171463