81 - 90 out of 580Page size: 10
  1. 2021

  2. Developing age-hardenable Al-Zr alloy by ultra-severe plastic deformation: Significance of supersaturation, segregation and precipitation on hardening and electrical conductivity

    Mohammadi, A., Enikeev, N. A., Murashkin, M. Y., Arita, M. & Edalati, K., 15 Jan 2021, In: Acta Materialia. 203, 16 p., 116503.

    Research output: Contribution to journal › Article › peer-review

  3. Calculation of hardening contributions of the TiNi alloy undergoing martensitic transformations in a free state

    Churakova, A. A., Gunderov, D. V., Tolstov, N. E. & Magomedova, D. K., 2021, In: IOP Conference Series: Materials Science and Engineering. 1008, 012038.

    Research output: Contribution to journal › Conference article

  4. Исследование механических свойств и поверхности разрушения цилиндрических образцов Аl-6101 при статическом растяжении

    Магомедова, Д. К., Чуракова, А. А. & Гундеров, Д. В., 2021, Актуальные проблемы механики сплошной среды: Материалы VII международной конференции 04-08 октября 2021, Цахкадзор, Армения. Ереван: Институт механики НАН РА, p. 167-171

    Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research › peer-review

  5. ЭВОЛЮЦИЯ СТРУКТУРЫ АМОРФНОГО СПЛАВА ZR42.5СU42.5AL10FE5 В ПРОЦЕССЕ ИПДК

    Базлов, А. И., Пархоменко, М. С., Убыйвовк, Е. В. & Гундеров, Д. В., 2021, p. 150-152. 3 p.

    Research output: Contribution to conference › Paper › peer-review

  6. 2020

  7. Stabilisation effect of strain hysteresis loop for steel 45

    Selyutina, N. S., Smirnov, I. V. & Petrov, Y. V., 31 Dec 2020, (E-pub ahead of print) In: International Journal of Fatigue. 106133.

    Research output: Contribution to journal › Article › peer-review

  8. Evolution of microstructure and hardness during artificial aging of an ultrafine-grained Al-Zn-Mg-Zr alloy processed by high pressure torsion

    Gubicza, J., El-Tahawy, M., Lábár, J. L., Bobruk, E. V., Murashkin, M. Y., Valiev, R. Z. & Chinh, N. Q., 1 Dec 2020, In: Journal of Materials Science. 55, 35, p. 16791-16805 15 p.

    Research output: Contribution to journal › Article › peer-review

  9. Microstructural changes and strengthening of austenitic stainless steels during rolling at 473 k

    Odnobokova, M., Belyakov, A., Enikeev, N., Kaibyshev, R. & Valiev, R. Z., Dec 2020, In: Metals. 10, 12, p. 1-18 18 p., 1614.

    Research output: Contribution to journal › Article › peer-review

  10. Dynamic Strength Analysis of Bitumen Binders for Asphalt Concrete Mixtures in Terms of the Fracture Incubation Time Criterion

    Smirnov, I. V. & Петров, Ю. В., Nov 2020, In: Physical Mesomechanics. 23, 6, p. 538-546 9 p.

    Research output: Contribution to journal › Article › peer-review

  11. Influence of high-pressure torsion and accumulative high-pressure torsion on microstructure and properties of zr-based bulk metallic glass vit105

    Gunderov, D., Astanin, V., Churakova, A., Sitdikov, V., Ubyivovk, E., Islamov, A. & Wang, J. T., Nov 2020, In: Metals. 10, 11, p. 1-14 14 p., 1433.

    Research output: Contribution to journal › Article › peer-review

  12. Strain Rate Dependences of the Critical Stresses in Aluminum Al–Mg Alloys upon Impact Loads

    Evstifeev, A. D., Smirnov, I. V. & Petrov, Y. V., Nov 2020, In: Physics of the Solid State. 62, 11, p. 1967-1972 6 p.

    Research output: Contribution to journal › Article › peer-review

Previous 1...5 6 7 8 9 10 11 12 ...58 Next

ID: 30105